5. Select the box to program.
When programming a new box, press [*Not Programmed].
To change a box already programmed, press it, and then proceed to step 8. If a password is
programmed, enter the password, press [OK], and then proceed to step 8.
6. Press [Information Box].
7. Enter a box name, and then press [OK].
8. Enter the SEP Code.
To change the SEP Code, press [Clear] or the [Clear/Stop] key, and then try again. To change the
box name, press [Box Name], and then repeat the procedure from step 7.
9. Press [Password].
If you do not want to program a password, proceed to step 12.
Box Settings
189
To Next Page
Loading...
Need help?
General
