Page Numbering in Combine
You can set page numbering when using the Combine function and the Page Numbering function
together.
Default: [Per Original]
Stamp on Designating Slip Sheet
You can select whether or not to print the page number onto slip sheets when using the Designate
function set to “Copy” and the Page Numbering function together.
Default: [Off]
Stamp Position
Specify how each of stamps is printed.
•
Stamp Position
Specify where to print the stamp.
Default for the patterns of “P1,P2...”, “1/5,2/5...”, “P.1,P.2...”, and “1,2...”: [Top Right]
Default for the patterns of “-1-,-2-...” and “1-1,1-2...”: [Bottom Centre]
• Adjust Stamp Position
You can adjust the position of the stamp within the available ranges shown below.
(mainly Europe and Asia)
“Top Left” T/B: 4 144 mm, L/R: 4 144 mm
“Top Centre” T/B: 4 144 mm, L/R: 72 72 mm
“Top Right” T/B: 4 144 mm, L/R: 4 144 mm
“Bottom Left” T/B: 4 144 mm, L/R: 4 144 mm
“Bottom Centre” T/B: 4 144 mm, L/R: 72 72 mm
“Bottom Right” T/B: 4 144 mm, L/R: 4 144 mm
(mainly North America)
“Top Left” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
“Top Center” T/B: 0.1 5.7 inches, L/R: 2.8 2.8 inches
“Top Right” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
“Bottom Left” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
“Bottom Center” T/B: 0.1 5.7 inches, L/R: 2.8 2.8 inches
“Bottom Right” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
Superimpose
You can have page numbers printed in white when they overlap black parts of the image.
Default: [Off]
Stamp
217
To Next Page
Loading...
