Ricoh Aficio MP 3352 - Stored Data in the Document Server

The relationship between the orientation in which you place the original and the punch hole
positions is as follows:
In the following illustration, two holes is specified, however the punch hole positions are the same
regardless of the number of holes.
CHF033
*2 *3
*2
*3
*1
*1
The above table shows punch hole positioning. Punched sheets might not be delivered in the orientation
shown in this table.
*2
If you want to punch holes in this position, select unreadable orientation in Original Orientation, and
then select the punch hole position.
*3
You cannot punch holes in this position when copying onto B4 JIS, 8 × 13 or larger, or 5
1
/
2
× 8
1
/
2
.
1. Press [Finishing].
2. Select one of the punch hole positions.
When the internal finisher is attached:
Finishing
89
2