Ricoh Aficio MP 4002 User Manual

Page 12 of 93
Copyright (c) 2012 RICOH COMPANY, LTD. All rights reserved.
Figure 2 : Hardware Configuration of the TOE
Controller Board
The Controller Board is a device that contains Processors, RAM, NVRAM, Ic Key, and FlashROM. The
Controller Board sends and receives information to and from the units and devices that constitute the MFP,
and this information is used to control the MFP. The information to control the MFP is processed by the
MFP Control Software on the Controller Board. The following describes the components of the Controller
Board:
- Processor
A semiconductor chip that performs basic arithmetic processing for MFP operations.
- RAM
A volatile memory medium which is used as a working area for image processing such as
compressing/decompressing the image data. It can also be used to temporarily read and write
internal information.
- NVRAM
A non-volatile memory medium in which TSF data for configuring MFP operations is stored.
- Ic Key
A security chip that has the functions of random number generation, cryptographic key generation

Ricoh Aficio MP 4002 Specifications

General

Print Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Duplex	Yes
Monthly Duty Cycle	150, 000 pages
Functions	Print, Copy, Scan, Fax
Maximum Paper Size	11" x 17"
Type	Monochrome Laser Multifunction Printer
Print Speed	40 ppm
Scan Resolution	600 dpi
Paper Capacity	Maximum: 4, 400 sheets
Connectivity	USB 2.0, Ethernet 10/100Base-TX
First Print Time	4.1 seconds
Zoom Range	25% - 400%
Fax Transmission Speed	Less than 3 seconds per page