Mac OS X
45
2
Mac OS X
This section explains how to configure a Mac OS X to use EtherTalk, USB and TCP/IP.
Follow the procedure below to configure Mac OS X 10.3.8. If you are not using
Mac OS X 10.3.8, see the manual of the Mac OS X you are using for details.
Important
❒ For Mac OS X 10.1 or higher.
Note
❒ The PPD files are stored in the following folder on the CD-ROM.
Mac OS X:PPD Installer
Installing the PPD Files
Follow the procedure below to install a PPD file to print from Mac OS X.
Important
❒ You need an administrator name and a password (phrase). For details, consult
your network administrator.
A Insert the CD-ROM into the CD-ROM drive.
B Double-click the CD-ROM drive icon.
C Double-click the [Mac OS X] folder.
D Double-click the [MacOSX PPD Installer] folder.
E Double-click the installer icon.
F Follow the instructions on the screen.
Setting Up the PPD File
A Start Printer Setup Utility.
B Click [Add].
• Mac OS X 10.4 or later
Click a printer that has “AppleTalk” indicated in the “Connection” column.
If the zone is set, click [More Printers...], and then select the zone from the
second pop-up menu.
•Other Mac OS X
Click [AppleTalk] on the first pop-up menu.
If the zone is set, select the zone from the second pop-up menu.
C Select the printer, and then select its manufacturer from the [Printer Model:]
pop-up menu.
Under Mac OS X 10.4 or later, you are using from the [Print Using] pop-up menu.
A list of printer types appears.
D Select the PPD file for the model you are using, and then click [Add].
E Quit Printer Setup Utility.
To Next Page
Loading...
