4. Remove the adhesive tape from the rear cover, and then open it.
5. Pull out the tape, and then remove the protective materials.
The actual printer may come with protective materials attached in different positions. Make sure to
check the printer's exterior for all protective materials, and remove them completely.
6. Make sure the levers are pulled up.
• If you leave the levers lowered, toner may not settle properly when printing on standard
paper. Make sure the levers are pulled up before printing on standard paper. If not, print may
easily smudge or rub off.
• After printing envelopes, make sure the levers are pulled up.
2. Installing the Printer and Options
28
To Next Page
Loading...
