2. Press the [ ] or [ ] key to display [Paper Input], and then press the [OK] key.
Menu:
Paper Input
3. Press the [ ] or [ ] key to display [Paper Type], and then press the [OK] key.
Paper Input:
Paper Type
4. Press the [ ] or [ ] key to display [Bypass Tray], and then press the [OK] key.
Paper Type:
Bypass Tray
5. Press the [ ] or [ ] key to select the paper type, and then press the [OK] key.
Bypass Tray:
Plain Paper
6. Press the [Menu] key.
Loading Paper in Tray 2
The following example explains the loading procedure for tray 2.
• Before printing on paper other than envelopes, make sure that the levers inside the rear cover are
pulled up. Leaving the levers lowered can cause print quality problems when printing on paper
other than envelopes.
• Make sure paper is not stacked above the limit mark inside the tray. Misfeeds might occur.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This printer does not detect the paper size automatically.
Loading Paper
85
To Next Page
Loading...
