Installing Options
34
3
D There are three pins on the top of
the paper feed unit that point
straight up. On the bottom of the
printer there are three holes.
Align the holes over the pins, and
then lower the printer gently onto
the paper feed unit.
E Attach the interface cable to the
printer.
F Plug the printer's power cable
back into the wall outlet, and then
turn on the power.
Note
❒ After finishing installation, you
can check whether the paper
feed unit is properly installed:
Print the configuration page
from the “List/Test Print”
menu. If it is installed properly,
you will see “Paper Feed Unit
(Tray 2)” or “Paper Feed Unit
(Tray 2), Paper Feed Unit (Tray
3)” under the “Options” list.
❒ If the paper feed unit is not in-
stalled properly, repeat the pro-
cedure from the start. If you
cannot install it properly even
after reinstallation, contact your
sales or service representative.
Reference
For printing the configuration
page, see p.28 “Test Printing”
See “Loading Paper”, Mainte-
nance Guide.
When adjusting the printing po-
sition, see “Adjusting Tray Reg-
istration”, Maintenance Guide.
AGN038S
ZKGX400E
KirP4GB_Setup-F6_FM_forPaper.book Page 34 Thursday, May 12, 2005 11:28 AM
To Next Page
Loading...
