Installing Options
52
3
Attaching Network Data Protection Unit
Type B
Important
❒ Protect the network data protec-
tion unit from physical shocks.
Note
❒ Use the under slot for the data pro-
tection unit.
A Check the package contains the
following:
❖ Network Data Protection Unit Type B
B Turn off the power of the printer,
and then unplug the power cable.
C Remove the card slot cover at the
back of the printer.
D Carefully insert the network data
protection unit, until the card
clicks into the place.
E Reattach the cover over the net-
work data protection unit. Fasten
the screw to secure the cover.
Note
❒ Do not touch the network data
protection unit while the ma-
chine is in use. It may come
loose, even if pushed only
slightly.
AET104S
AGN011S
AGN002S
AGN012S
KirP4GB_Setup-F6_FM_forPaper.book Page 52 Thursday, May 12, 2005 11:28 AM
To Next Page
Loading...
