Attaching Memory Unit Type C 256MB (SDRAM Module)
37
3
E Pull the handle, and then slide
the controller board out.
F Place the controller board on a flat
surface.
G The memory unit is installed in
the slot shown in the illustration
below.
H Remove the default memory unit
before installing a new memory
unit. Press down the levers on
both sides to remove the default
memory unit.
I Align the notch of the memory
unit to the slot, and then push it
down until it clicks.
J Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
K Push the handle of the controller
board until it clicks.
ZKGX260E
ZKDX021J
AGN016S
ZKGX130E
ZKGX250E
ZKGX380E
KirP4GB_Setup-F6_FM_forPaper.book Page 37 Thursday, May 12, 2005 11:28 AM
To Next Page
Loading...
