• When loading coated paper:
• If you want to use glossy paper, select [Coated: Glossy] for [Paper Type]. If you want to use
matted paper (including silk, dull, and satin paper), select [Coated: Matte] for [Paper Type].
For details about the settings for using coated paper with custom paper, see page 57
"Registering a Custom Paper".
• When loading coated paper or glossy paper, always fan the paper before using it.
• If a paper jam occurs or if the machine makes a strange noise when feeding stacks of coated
paper, feed the coated paper one sheet at a time.
• To load coated paper into the wide LCT, you must specify [Coated: Glossy], [Coated: Matte],
or [Coated: High Gloss] as the paper type and select an appropriate paper thickness under
[Paper Weight].
Envelopes
This section describes loading envelopes.
• Misfeeds might occur depending on the length and shape of the flaps.
• Only envelopes that are at least 139.7 mm (5.5 inches) wide can be loaded.
To print on envelopes, load them into the Wide LCT or multi bypass tray (Tray A), and be sure to specify
an appropriate paper type.
To load envelopes, be sure to unfold their flaps and set them in the orientation with print side face up.
If you are printing onto side-opening envelopes, be sure to unfold their flaps and set them in the
orientation with print side face up. Flaps must be at the right side of the Wide LCT or multi bypass tray
(Tray A).
Recommended Paper
55
To Next Page
Loading...
