122
Paper deflection
Because of high paper friction, the delivered sheet may arch up and become
crimped.
Output tray
Paper exit
Paper feed direction
CEZ596
Solution:
Depending on the cause of the problem, do one of the following:
<Sheet bending>
The auxiliary tray is not attached.
• If using paper of Paper Weight 3 or lower, attach the auxiliary tray for thin
coated paper.
For details about attaching the auxiliary tray for thin coated paper, see "Using
Thin Coated Paper" in the Troubleshooting supplied with the machine.
• If using paper of Paper Weight 4 or higher, attach the auxiliary paper tray.
For details about attaching the auxiliary paper tray, see "Using Thick Coated
Paper" in the Troubleshooting supplied with the machine.
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is attached>
1.
In the [Adjustment Settings for Skilled Operators] menu, set [0116: Adjust
Paper Curl] to "Adjust Curl".
To control the level of decurling, select "Weak" if the present setting is "Off"
or "Strong" if the present value is "Weak".
<If the decurler unit is not attached>
1.
Load the sheets the other way up.
To Next Page
Loading...
Need help?
General
