131
<How to adjust the folding deviation>
This procedure is the same for L1, L2, and L3.
1. Open the front cover of the multi-folding unit.
2. Remove the mounting screw.
If the mounting screw is attached to the adjusting screw hole, unfasten it.
3. Turn the adjusting screw to adjust the deviation.
• To increase the length at the bottom part of paper, turn the screw clockwise.
• To decrease the length at the bottom part of paper, turn the screw
counterclockwise.
CEZ510
4. Attach the mounting screw to fasten the adjusting screw.
If the mounting screw is attached to the adjusting screw hole, fasten it.
5. Close the front cover of the multi-folding unit.
Note:
• For multi-sheet folding, the folding deviation that appears in the center of paper
will be adjusted.
• If the deviation is large, the paper may be skewed. For further information, see
p.84 "Paper Skew".
To Next Page
Loading...
Need help?
General
