Ricoh D146 - Page 750

Main SP Tables-1
System Maintenance Section 2-31 D146/D147/D148/D149/D150
SP Mode Tables
020
Thick1:BW:Press *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: thick paper 1: BW: pressure
021
Thick2:FC:Center *ENG [100 to 180 / 130 / 1deg/step]
paper through target temperature: thick paper 2: FC: center
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
022
Thick2:FC:Press *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: thick paper 2: FC: pressure
023
Thick2:BW:Center *ENG [100 to 180 / 130 / 1deg/step]
Paper through target temperature: thick paper 2: BW: center
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
024
Thick2:BW:Press *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: thick paper 2: BW: pressure
025
Thick3:FC:Center *ENG [100 to 180 / 135 / 1deg/step]
Paper through target temperature: thick paper 3: FC: center
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
026
Thick3:FC:Press *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: thick paper 3: FC: pressure
027
Thick3:BW:Center *ENG [100 to 180 / 135 / 1deg/step]
Paper through target temperature: thick paper 3: BW: center
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
028
Thick3:BW:Press *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: thick paper 3: BW: pressure