Ricoh D5530 - Set Monitor ID; Motion Detection; Advanced

When [Auto] is set and the video input source is switched, the device connected to the USB hub of the
machine may not be recognized. In that case, connect the USB device again, pair the Bluetooth devices
again, or turn the machine on and off.
Set Monitor ID
Assigns an ID number for the current machine when multiple displays are connected.
For use when the machine is controlled by the signal from the RS-232C Input terminal.
Motion Detection
Detects a person approaching the display and exits standby mode automatically when a controller that
supports OPS (Open Pluggable Specification) is connected to the display.
• On
Enables the motion detection function.
• Off
Disables the motion detection function.
Advanced
Auto Search
• If turned [On], the display automatically detects available input sources.
• When the controller designed compliant with OPS (Open Pluggable Specification) standard is
connected to this display, Auto Search is fixed to [Off].
Auto Adjustment
Sets whether to optimize image display for each VGA input.
Overscan
Changes the display area of the image. When this function is enabled, 96% of the original size of
the image will be displayed, and the rest of the areas surrounding the image will be cut off.
This can be set when HDMI or DisplayPort is selected as the input source.
• On
Enables the Overscan function for Video timing.
• Off
Disables the Overscan function.
The Overscan function will become unavailable (grayed out) when:
4. The On-Screen Display Menu
38