4.8 ERASE LAMP REPLACEMENT
1. Remove the following parts:
• Development unit
• Drum unit
• Main board
2. Lower the transfer belt unit and place a sheet of paper [A] over the transfer
belt.
NOTE: This step prevents the erase lamp from damaging the transfer belt if
it falls.
3. Remove the screw [B] and push the erase lamp [C] halfway in from the front
until its front end does not fall down.
4. Remove the erase lamp [C] from the back of the copier.
[A]
[B]
[C]
FSM 5-25 FT5535/4527/4522
To Next Page
Loading...
