Ricoh FT5535 - Page 156

7.2 LCT DRIVE BELT REPLACEMENT
1. Remove the LCT unit (see "LCT Unit Removal").
2. Remove the upper belt cover [A] (4 screws).
3. Remove the lower belt cover [B] (1 screw).
4. Remove the front cover [C] (3 screws).
5. Remove the grip holding bracket [D] and grip bracket [E] (2 screws).
6. Remove the belt stoppers [F] (1 screw each).
7. Remove the upper pulley [G] and LCT drive belt [H] (1 E-ring each).
NOTE: When reinstalling the belt stoppers, make sure that the LCT bottom plate
is at the bottom.
[G]
[H]
[A]
[F]
[B]
[F]
[H]
[G]
[D]
[E]
[C]
FT5535/4527/4522 5-40 FSM