Ricoh FT5535 - Page 79

Mode No. Function Settings
4-901 APS Size
Priority (for F4
size) †
Selects which copy paper size the machine
selects when the APS sensors detect F4
lengthwise (8
1/2" x 13").
0: 8
1/2" x 13"
1: 8" x 13"
2: 8
1/4" x 13"
•
°4-902 APS 8K/16K
Detection †
(A4 versions
only)
Selects whether the machine can select
8K/16K copy paper based on APS sensor
readings.
If "YES" is selected, 8K/16K copy paper is
selected under the following conditions:
0: NO
1: YES
•
°5-001 All Indicators
ON †
Turns on all indicators on the operation panel.
•
°5-002 Feed Station
Priority
Selection †
Selects the paper feed station priority. 1 ~ 6: Non duplex
machines
1 ~ 5: Duplex
machines
Default = 1
(without LCT)
Default = LCT (5
or 6)
(with LCT)
•
°5-003 APS Priority
Selection †
Specifies whether the copier defaults to APS
or manual mode when the main switch is
turned on, auto reset, or mode cleared.
1: APS
0: Manual
Also see
SP6-010.
•
°5-004 ADS Priority
Selection †
Specifies whether the copier defaults to ADS
or manual ID mode when the main switch is
turned on, auto reset, or mode cleared.
1: ADS
0: Manual
•
°5-013 Counter
Up/Down
Selection †
Selects whether the counter counts up or
down.
1: Up
2: Down
•
°5-017 Maximum Copy
Quantity †
(Copy Limit)
Limits the maximum copy quantity that can be
entered.
1 ~ 999
Default = 999
•
°5-019-001
to
5-019-008
Paper Size Set
†
Sets the paper size for each paper tray and
feed station.
For how to input
the settings, see
section 2.7.
Size detected
by APS
Selected copy paper
size
B4 lengthwise
8K lengthwise
(267 mm x 390 mm)
A4 lengthwise
16K lengthwise
(267 mm x 195 mm)
B5 sideways
16K sideways
(115 mm x 267 mm)
Setting
Non duplex
machines
Duplex
machines
1 1st Tray 1st Tray
2 2nd Tray 2nd Tray
3 3rd Tray 3rd Tray
4 4th Tray 4th Tray
5 5th Tray LCT
6 LCT —
Rev. 7/95
FT5535/4527/4522 4-28 FSM