Mode No. Function Settings
•
°5-110 Center Erase
Margin
Adjustment †
Adjusts the center erase margin width in erase
center mode.
A4 version
8 ~ 25
Default = 20
LT version
0.32 ~ 1.00
Default = 0.80
SP5-908 must be at 1 for this to have any
effect.
(A4 version: 1 mm per step [Range: 8 mm
to 25 mm],
LT version: 0.01" per step [Range: 0.32" ~
1.00"])
°5-113 Coin Lock
Installation †
Specifies whether coin lock is installed or not
(only for Japanese versions).
0: Not installed
1: Installed
5-115 Duplex Image
Shift †
(Back Side
Margin)
Specifies whether duplex image shift (back
side margin) is used or not.
0: NO
1: YES
If "YES" is selected, a 5 mm margin is made
on the right of the reverse side of copies when
making two-sided copies from one-sided
originals.
If the image shift mode has been selected with
SP5-908 and if the user uses image shift
mode, this SP mode has no effect.
°5-121 T/C (Total
Counter) Count
Up Timing †
Determines whether the total counter counts
up at paper feed or at paper exit.
0: Feed
1: Exit
•
°5-305 Auto Off Time
Setting †
Sets the time to go into the auto off condition. 1 ~ 120 minutes
(1minute per step)
(Default: 60
minutes)
°5-401 User Code
Mode †
After JP2 on the main board is cut, either key
counter mode or user code mode can be
selected with this SP mode.
0: Key Counter
1: User Code
•
°5-402 User Code
Counter Check
†
Displays the user code counters.
The current user code is displayed in copy
counter, and the copy count for that user code
is displayed in the reduce/enlarge indicator.
Hold down the "•" key to display the last three
digits.
Use the and keys to check each
user code counter.
Rev. 1/26/96
⇒
FT5535/4527/4522 4-30 FSM
To Next Page
Loading...
