Ricoh Gestetner 5430 - 5 Service Tables; Using Service Program Modes; Accessing Sp Modes; Entering SP Mode

31 October 2001 USING SERVICE PROGRAM MODES
5-1
Service
Tables
5. .SERVICE TABLES
5.1 USING SERVICE PROGRAM MODES
Use the service program modes (SP modes) to check electrical data, change
operating modes, and adjust values.
5.1.1 ACCESSING SP MODES
Entering SP Mode
1. Key in the following sequence.
Method 1:
!
→
"
→
#
→
$
→
%
• Hold the % key down for longer than 3 seconds.
Method 2:
!
→
%
→
Combine key
→
&
2. The zoom counter displays “SP1”.
3. Go to section 5.1.2.
Leaving SP Mode
Press the
!
key one or more times.