To Next Page
I
Isabel RodriguezAug 3, 2025
How to reset SC on Ricoh G147?
- JJack WilsonAug 3, 2025
To reset the SC and allow operation of your Ricoh All in One Printer, enter SP mode, then turn the power switch off and on.
How to reset SC on Ricoh G147?
To reset the SC and allow operation of your Ricoh All in One Printer, enter SP mode, then turn the power switch off and on.
What to do if Ricoh G147 All in One Printer circuit board has a problem?
If you're experiencing issues with a circuit board on your Ricoh All in One Printer, it's often due to a loose or disconnected harness. Before replacing the PCB, disconnect and reconnect the connectors to ensure they are properly seated. This simple step can often resolve the problem.
What to do if Ricoh All in One Printer motor lock error occurs?
If a motor lock error occurs on your Ricoh All in One Printer, check the mechanical load before replacing any parts. Inspect the motor and sensors to ensure they are functioning properly before proceeding with a replacement.
General| Print Technology | Laser |
|---|---|
| Functions | Print, Copy, Scan, Fax |
| Print Resolution | 1200 x 1200 dpi |
| Copy Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Fax Transmission Speed | 33.6 kbps |
| Paper Capacity | 250 sheets |
| Maximum Paper Size | A4 |
| Connectivity | Ethernet, USB |
| Interface | USB 2.0, Ethernet 10/100Base-TX |
| Operating System Compatibility | Windows, Mac OS |
