Ricoh G147 - Service Program Mode Tables; Service Table Key; Service Tables

G147 5-6 SM
5.2 SERVICE PROGRAM MODE TABLES
5.2.1 SERVICE TABLE KEY
Notation What it means
[range / default / step]
Example: [–9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with each
key press.
italics Comments added for reference.
DFU
Denotes “Design or Factory Use”. Do not change this value.
Japan Only
The feature or item is for Japan only. Do not change this value.
NIA
No Information Available (April 2006)
5.2.2 SERVICE TABLES
SP1-xxx: Feed
Subscan Reg Adj Leading Edge Registration
1001
Adjusts the printing leading edge registration using the trimming area pattern
(SP2-902-3, No.10).
[+9 ~ –9 / 3.0 / 0.1 mm]
Use [./] to toggle between + and – before entering the value. Specification: 3 ±2
mm
Side-to-Side Reg Side-to-Side Registration
1002
Adjusts the printing side-to-side registration from the 3rd paper feed station using
the trimming area pattern (SP2-902-3, No.10). Tray 3, Tray 4 are for the optional
Paper Feed Unit.
Use the [./] key to toggle between + and – before entering the value.
Specification: 2 ±1.5 mm
001 Tray-1 [–9 ~ +9/ +3.0 mm / 0.1 mm step]