PUNCH WASTE COLLECTION
B377 4 SM
2.2 PUNCH WASTE COLLECTION
Waste punchouts are collected in the punch waste hopper [A] below the punch unit
inside the finisher.
When the top of the punchout waste in the hopper reaches and actuates the
hopper sensor [B], a message will be displayed on the operation panel after the
current job is completed.
This sensor also detects whether the punch waste hopper is installed. When the
waste hopper is taken out, the arm [C] moves down and this will actuate the sensor
and display a message in the operation panel. This message is the same as for the
hopper full condition.
B377D506.WMF
[C]
[B]
[A]
To Next Page
Loading...
