G147 1-22 SM
the procedure and contact your Sales Division.
3. When you remove each seal, the “VOID” marks [2] can be seen. In this condition,
they cannot be attached to the box again.
1.8.3 INSTALLATION PROCEDURE: DOS UNIT
The DOS SD card must be inserted in SD card slot C1. Make sure that the Data
Overwrite Security Option B735 is "Type C".
1. If the machine is on, turn off the power switch.
2. Disconnect the network cable.
3. Turn the power switch on.
4. Turn the power switch off.
5. Remove the SD card slot cover [1] ( x1).
6. With the printed side of the SD card [2] facing the rear of the machine, install the
To Next Page
Loading...
