G147 6-54 SM
When the paper enters the gap between the belt and the drum, the high voltage supply
board [E] applies a high positive current to the belt to transfer the image to the paper.
After receiving the image from the drum, the paper is fed by the belt. The paper moves to the
end of the transfer belt unit, where it separates from the belt as the belt curves away. Then
the paper moves on to the fusing unit.
6.12.5 TRANSFER BELT CHARGE
Transfer Belt Charge Mechanism
The high voltage supply board [A] applies a positive current to the transfer belt [B] through
To Next Page
Loading...
