G147 5-128 SM
Acronym Meaning
SCS System Control Service
SRM System Resource Management
WebDB Web Document Box (Document Server)
The machine is now set to record the debugging information automatically on the SD card or
HDD (the target selected with SP5857-002) for the events that you selected SP5858 and the
memory modules selected with SP5859.
Please keep the following important points in mind when you are doing this setting:
The initial settings are all zero.
These settings remain in effect until you change them. Be sure to check all the settings,
especially the settings for Keys 6 to 10. To switch off a key setting, enter a zero for that
key.
You can select any number of keys from 1 to 10 (or all) by entering the corresponding
4-digit numbers from the table.
One area of the disk is reserved to store the debug log. The size of this area is limited to
4 MB.
5.12.2 RETRIEVING THE DEBUG LOG FROM THE HDD
1. Insert the SD card into service slot C3.
2. Enter the SP mode and execute SP5857 009 (HDD for SD (4MB)) to write the
debugging data to the SD card.
3. Use a card reader to copy the file and send it for analysis to your local Ricoh
representative by email, or just send the SD card by mail.
5.12.3 MORE ABOUT DEBUG LOG
SP5857-015: SD to SD (Any)
This SP copies the log on an SD card (the file that contains the information written directly
from shared memory) to a log specified by key number. The copy operation is executed in
the log directory of the SD card inserted in the same slot. (This function does not copy from
one slot to another.)
Each SD card can hold up to 4 MB of file data. Unique file names are created for the data
during the copy operation to prevent overwriting files of the same name. This means that log
data from more than one machine can be copied onto the same SC card.
This command does not execute if there is no log on the HDD for the name of the specified
key.
To Next Page
Loading...
