Ricoh G147 - Printer Controller Bit Switch Settings

SM 5-3 G147
Service
Tables
4. Select the “0” or “1” for each position. The leftmost digit is 7 and the rightmost is
0.
 Press " or $ to move the cursor to the right or left to position the it at the digit to
change.
 Press [#Enter] then press " or $ to toggle the digit between “1” and “0”.
 With the digit for entry displayed on the second line, press [#Enter]. The selected
digit is entered into the position above.
 Repeat this procedure to set all the digits.
5. When you are finished, press [Escape] to return to the previous level. The new
settings for the bit switch are now stored.
Printer Controller Bit Switch Settings
Position: 7 6 5 4 3 2 1 0
Display: 0 0 0 0 0 0 0 0
Bit Switch 1 Default
0 0
1 0
2 1
3 0
4 0
5 0
6 0
7 0
Bit Switch 2 All "0"
Bit Switch 3 All "0"
Bit Switch 4 All "0"
Do not change these settings.