G147 5-102 SM
5.5 OUTPUT CHECK
Motors keep turning in this mode regardless of upper or lower limit sensor signals.
To prevent mechanical or electrical damage, do not keep an electrical component
on for a long time.
Enter the SP mode and select SP5804.
1. Press "$ together (for 5 seconds), release, then press [#Enter].
System Ver.1.00
1. Service
2. Press $.
System Ver. 1.00
2. Engine
3. Press [#Enter].
<Engine>
1. Feed
4. Press $ to display “5. Mode”.
<Engine>
5. Mode
5. Press [#Enter].
SP5024
mm/inch Display
6. Press $ repeatedly to display “Output Check”.
SP5804 >>
Output Check
7. Press [#Enter].
SP5804-001
1st.PaperFeedCl.
8. Press " or $ to display the item to check.
SP5804-027
Fuser Exit Motor
To Next Page
Loading...
