Ricoh G147 - Printer Controller Service Mode

G147 5-2 SM
1.Service Controller service settings.
2.Engine Engine service settings.
3.End Leave the SP mode and return to normal operation.
1. With the item that you want to open displayed in the LCD, press[#Enter].
2. Press " or $ to display all the menus on the same level, then press [#Enter] to
open the submenus.
3. Push [Escape] to the highest level, or push " or $ to display “3.End” then press
[#Enter].
5.1.3 PRINTER CONTROLLER SERVICE MODE
Controller Service Mode Menus
The controller service mode menu (1.Service) is the first item on the menu.
Item What It Does
Bit Switch Adjusts the bit switch settings.
Clear Setting Initializes the settings for the “System” menu of the user mode.
Print Summary Prints a summary of all the controller settings.
Display Version Displays the current version number of the controller firmware.
Bit Switch Programming
1. Enter the SP mode, select “1.Service”, and press [#Enter] twice
SP1001-001
Bit Switch 1 Set
2. Press " or $ to select the bit switch setting to change.
SP1001-002
Bit Switch 2 Set
3. Press [#Enter].
Sw#2 00000000
bit0 _