G147 5-4 SM
5.1.4 PRINTER ENGINE SERVICE MODE
The Printer Engine Service mode is used to check electrical data, change modes, and adjust
values.
Here is a quick summary of how to enter and use the Printer Engine Service mode to
change the settings listed in the Service Program Mode Tables.
1. Press
and $ together, hold down for over 5 seconds, release and then press
[#Enter].
2. Press
or $ to display “2.Engine”.
3. Press [#Enter].
4. Press " or $ to display the SP code groups.
1. Feed SP1000
2. Drum SP2000
3. Process SP3000
5. Mode SP5000
6. Periphs SP6000
7. Data Log SP7000
8. Data Log2 SP8000
9. Etc. SP9000
1. Press " or $ to select the group, and then press [#Enter].
The 2-line display is rotational. If you press " with “1.Feed” displayed, the
display will jump to "9. Etc.", the last selection. Similarly, if you press " with
“9.Etc” displayed, the display will jump to “1.Feed”, the first selection.
2. While referring to the Service Program Mode Tables, press " or $ to select the
SP that you want to change, and then press [#Enter].
If you see > or >> to the right of a selection name, this means a menu sublevel
exists.
3. Follow one of the procedures below to change a setting.
To Next Page
Loading...
