SM 3-7 G147
Replacement
Adjustment
3.4 OPERATION PANEL
The fusing unit below the cover is hot. Allow the machine to cool for 10 minutes
before you begin the procedure.
1. Fusing unit cover [A] (caps x 2,
x 2)
Insert the tip of a screwdriver into the slot to release the plastic hook and lift. Exert very
little pressure to avoid breaking the hooks.
2. After removing the screws, slide cover [B] forward to remove it.
Before re-installing the cover, open the duplex unit and carefully insert the brackets on
the bottom of the cover into the slots [C].
3. Operation panel [D] (
x 2, x 2)
Turn over the fusing unit cover and pull off the operation panel to expose the connector.
To Next Page
Loading...
