Ricoh G147 - Leaving the Sp Mode

SM 5-5 G147
Service
Tables
To change a single-digit number setting:
 Press [#Enter]. A number replaces the cursor.
 Press " or $ to increase or decrease the number.
 Press [#Enter]. The number selected on the 2nd line replaces the number above.
 Press to return to the previous level.
To change a multiple-digit number setting
 Press " or $ to move the cursor to the digit that you want to change.
 Press [#Enter]. A number replaces the cursor.
 Press " or $ to increase or decrease the number.
 Press [#Enter]. The number selected on the 2nd line replaces the number above.
 Repeat the procedure to enter numbers for the other digits.
 Press #(Escape) to return to the previous level.
To select an item from a list
 The current selection is marked with a large asterisk ().
 Press " or $ to display on the 2nd line the item to select.
 With the item that you want to select displayed on the second line, press [#Enter].
The selected item is marked with an asterisk.
 Press [Escape] to return to the previous level.
5.1.5 LEAVING THE SP MODE
1. When you are finished with SP selection, press [Escape] until you see “2.Engine”.
2. Press $ to display “3.End”.
3. Press [#Enter] to display “Offline”.
4. Press [Online] to set the printer online.
 Powering the printer off and on leaves the SP mode, and returns the printer
online in normal operation mode.