SM 5-7 G147
Service
Tables
002 Tray-2 [–9 ~ +9/ +3.0 mm / 0.1 mm step]
003 Tray-3 [–9~ +9/ +2.0 mm / 0.1 mm/step]
004 Tray-4 [–9~ +9/ +2.0 mm / 0.1 mm/step]
005 Duplex Tray [–9 ~ +9/ +0.0 mm / 0.1 mm/step]
006 Bypass Tray [–9 ~ +9/ +3.0 mm / 0.1 mm/step]
007 LCT [–9 ~ +9/ +1.5 mm / 0.1 mm/step]
Regis Buckle Adj Registration Buckle Adjustment
1003
Adjusts the relay clutch timing at registration. Relay clutch timing determines the
amount of paper buckle at registration. (A “+” setting causes more buckling.)
001 Trays 2,3,4, LCT
002 Duplex Tray
003 Bypass Tray
[–9 ~+9 / 0 /1 mm step]
004 Tray-1 [–9 ~+9 / 1 /1 mm step]
005 By-pass Thick [–9 ~+9 / -2 /1 mm step]
By-pass SizeDisp DFU
By-pass Feed Paper Size Display
1007
Displays the paper width sensor data for the by-pass feed table. The detected
paper size display is shown as bit settings in an 8-digit display.
(7)1110 0000(0)
Exit Jct. SOLs Exit Junction Solenoid Start Timing
1012
Adjusts the timing of the solenoids at the entrance and exit of the paper exit
section to accommodate the increased speed of the duplex unit.
This SP has been added to compensate for the increased operation speed of the
duplex unit for this machine. Increase the value if the leading edges are jamming.
Decrease the value if trailing edges are bending at the entrance
To Next Page
Loading...
