G147 5-8 SM
001 Exit Start SOL [200 ~ 450 ms / 300 ms /10 ms]
002 Exit End SOL [200 ~ 450 ms / 370 ms /10 ms]
Fusing Idling
1103
Switches fusing idling on/off. When on, printing will not start until enough time has
elapsed so the hot roller can reach optimum temperature. This ensures even heat
on the hot roller.
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if the
room is cold.) You must switch SP1103-1 ON before you set the fusing interval
with SP1103-2.
001 0:OFF 1:ON 0 = Off, 1 = On
002 Interval(s) [0 ~ 60 sec. / 30 sec. / 1 sec.]
Fusing T Ctrl Fusing Temperature Control
1104
Selects the fusing temperature control method. After changing this setting, be
sure the power the machine off and on again with the power switch to enable the
new setting.
[0~1 / 0 / 1]
0: Normal (ON/OFF control). Allows full application from ac power supply to bring
the hot roller up to the target fusing temperature then shuts off. Determines the on
time from the present temperature (detected by the thermistor on the hot roller)
and the temperature of 1 cycle before.
1: Phase (hysterisis) control. Sets the upper and lower limits for the temperature;
at the lower temperature the fusing lamp is on and at the higher temperature the
fusing lamp is off.
Change this setting to “0” only if the user has excessive electrical noise or
interference on the power supply line. Such interference can cause voltage to
drop when power is applied using the ON/OFF control method.
Interference can be caused by the general poor quality of the power supply lines,
or if the machine is sharing a power supply with other electrical devices such as
fluorescent lights. Before changing this setting, make sure that the machine is
connected to a power supply not shared by other electrical equipment.
To Next Page
Loading...
