SM 8-25 J001/J003
(3) If the spooling operation is no longer in
progress, do the procedure below.
3-1 Disconnect the USB cable.
3-2 Switch printer power off/on
3-3 Cancel the print job on the PC.
3-4 Reboot the PC.
If the spooling operation is no longer in progress,
do the procedure below.
1. Disconnect the USB cable.
2. Switch printer power off/on
3. Cancel the print job on the PC.
4. Reboot the PC.
(4) ST Descriptions
4-1 Operation impaired by other causes.
Control board defective.
Replace control board (NRC).
To Next Page
Loading...
