Nozzle check starts.
● If the condition of the print-heads is not satisfactory, perform head cleaning again. However, the heads may remain clogged and the
printer may not print properly even if you clean the heads multiple times. If this happens, perform a full print head cleaning. If there is
still no improvement, turn the printer off, and then leave it turned off for at least 8 hours. This may solve the problem.
● Opening from the Start Menu
● Opening from an Application
● Nozzle Check
● Clean Print-heads (Full)
Top Previous Next
Copyright © 2005 All rights reserved.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0084.htm (2 of 2)2005/10/05 12:04:18
To Next Page
Loading...
