❍ Pull tray 1 completely out. Take care not to drop it.
3. Squeeze the paper guides on both sides, and then adjust them according to the paper size.
❍ Beforehand, make sure to squeeze the front end paper guide, and then expand the guide.
4. Load inkjet transparency into tray 1 with the notched corner in the right front corner of the tray. Do not
load transparencies over the limit mark.
❍ Curled inkjet transparency may jam. Straighten any curls before loading.
❍ If other paper is loaded, remove it, and then load inkjet transparency.
❍ To prevent the leading edge of transparencies from being scratched, place transparencies one at a time.
5. Squeeze the front end paper guide, and then slide it to meet the edge of the inkjet transparency.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/acc/0007.htm (2 of 4)2005/10/05 12:06:16
To Next Page
Loading...
