Troubleshooting > Printer Status Monitor Errors > No Paper/Tray Not Detected (Bypass Tray)
No Paper/Tray Not Detected (Bypass Tray)
If no paper is ready to be fed in the bypass tray, this message appears. Follow the procedure below to insert paper into
the bypass tray.
1. Slide the bypass tray guides into position according to the paper size.
2. Insert a sheet of paper into the bypass tray with the print side face up.
Printing starts when you push in the paper.
Printing cannot start until the machine finishes cleaning its head. Load the paper in the bypass tray when
cleaning finishes.
❍ When using the bypass tray, make sure the envelope or sheet of paper is between the top and bottom of the bypass tray guides.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/acc/t0009.htm (1 of 2)2005/10/05 12:08:33
To Next Page
Loading...
