CIP Training L5160/L5130
Basic Operation
Performing Head Cleaning
1. Press the [Maintenance] key.
DWU102
2. Press [Nozzle Cleaning].
3. Press [Nozzle Cleaning: Low] or [Nozzle Cleaning: High].
4. Select which print heads to clean from [Head 1], [Head 2], or [Head 3], and then press
[Execute].
You can select multiple print heads simultaneously. To perform all print heads, press [Clean
All Print Heads].
5. After the message is displayed, press [Execute].
Head cleaning will be performed.
6. Press [Confirm].
7. Press [Close].
8. Perform test printing again to check the printing result.
Perform cleaning and test printing repeatedly until the printing result is normal.
To Next Page
Loading...
