CIP Training L5160/L5130
Basic Operation
• If the waste ink bottle is full, a message will appear on the control panel and auto
maintenance will not be executed. If the message appears, replace the waste ink bottle. For
details, see "Replacing a Waste Ink Bottle".
Configuring Auto Maintenance Interval
The setting procedure for the maintenance frequency of each auto maintenance item is the
same. This section uses the procedure for the flushing interval as an example.
1. Press the [Maintenance] key.
DWU102
2. Press [ ].
3. Press [Auto Maintenance].
4. Press [Flushing Interval].
When setting other maintenance items, select the desired item.
5. Select a level from [Level 1 (Lo)], [Level 2], or [Level 3 (Hi)].
Maintenance is more frequent the higher the level: [Level 1 (Lo)] [Level 2] [Level 3 (Hi)]
6. Press [Close].
7. Press [End].
To Next Page
Loading...
