Copying from the Bypass Tray
27
2
B Select the paper type, and then
press the {OK} key.
The “
Programmed” message ap-
pears.
When copying onto envelopes
A Select [Paper Size] using {U} or
{T}, and then press the {OK}
key.
B Select [Regular Size] using {U}
or {T}, and then press the {OK}
key.
C Select the envelope size from
[C6 envL] [C5 envL] [DL envL],
and then press the {OK} key.
The “Programmed” message ap-
pears.
D Press the {#} key.
E Select [Paper Type] using {U} or
{T}, and then press the {OK}
key.
F Select [Thick Paper] using {U} or
{T}, and then press the {OK}
key.
The “
Programmed” message ap-
pears.
F Place your originals, and then
press the {Start} key.
Note
❒ When copying onto OHP trans-
parencies, remove copied sheets
one by one.
G When your copy job is finished,
press the {Clear Mode} key to clear
settings.
KirC3L_copy_F-EN_FM.book Page 27 Tuesday, November 1, 2005 12:12 PM
To Next Page
Loading...
