• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see page 153
"Recommended Paper Sizes and Types".
1. Open the bypass tray.
2. Load the paper face down until you hear the beep.
3. Align the paper guides to the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
• When you use the bypass tray, it is recommended to load the paper in orientation.
•
Certain types of paper might not be detected properly when placed on the bypass tray. If this
happens, remove the paper and place it on the bypass tray again.
• Pull the extender out when loading sheets larger than A4
, 8
1
/
2
× 11 in the bypass tray.
•
When loading thick paper, thin paper, or OHP transparencies, specify the paper size and the
paper type.
• Letterhead paper must be loaded in a specific orientation. For details, see page 150 "Loading
Orientation-fixed Paper or Two-sided Paper".
Loading Paper
143
To Next Page
Loading...
