EasyManuals Logo

Ricoh MP 3054 Series User Guide

Ricoh MP 3054 Series
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
DCG015
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
DCG016
3. Carefully push the paper tray fully in.
Various sizes of paper can be loaded in the paper trays by adjusting the positions of side fences
and end fence. For details, see "Changing the Paper Size in Paper Trays", Paper Specifications and
Adding Paper.
You can load envelopes in the paper trays. When loading envelopes, place them in the correct
orientation. For details, see page 179 "Envelopes".
Loading Paper into the Bypass Tray
Use the bypass tray to use OHP transparencies, adhesive labels, translucent paper, and paper that
cannot be loaded in the paper trays.
9. Adding Paper and Toner
160

Table of Contents

Other manuals for Ricoh MP 3054 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh MP 3054 Series and is the answer not in the manual?

Ricoh MP 3054 Series Specifications

General IconGeneral
Print Speed30 ppm
Copy Resolution600 x 600 dpi
Duplex PrintingYes
Monthly Duty Cycle50, 000 pages
Maximum Paper SizeA3
Warm-up Time20 seconds
Memory2 GB RAM
Scan Resolution600 dpi
Paper Capacity4, 700 sheets
ConnectivityUSB 2.0, Ethernet 10/100Base-TX
FunctionsPrint, Copy, Scan
Scan Speed80 ipm (simplex)
Control PanelTouchscreen
First Print Speed4.6 seconds
Hard Disk Drive320 GB
Fax Transmission Speed33.6 kbps
Operating System CompatibilityWindows, Mac, Linux
Print ResolutionUp to 1200 x 1200 dpi

Related product manuals