Ricoh MP 3054 Series User Guide

Message Cause Solution
"Cannot detect the paper
size of the original. Specify
the scanning size."
The set original was
misaligned.
• Place the original correctly.
• Specify the scan size.
• When placing an original directly
on the exposure glass, the lifting/
lowering action of the exposure
glass cover or the ADF triggers
the automatic original size
detection process. Lift the
exposure glass cover or the ADF
30 degrees or more.
"Cannot specify any more
scanning area."
The maximum number of
registrable scan modes has
been exceeded.
The maximum number of scanning
areas that can be stored is 100. Delete
unneeded scanning areas.
"Clear Misfeed(s) in ADF." A paper misfeed has
occurred inside the ADF.
• Remove the jammed originals,
and then insert them again. For
details about jammed paper, see
"Removing Jammed Paper",
Troubleshooting.
• When a misfeed occurs, replace
the jammed originals.
• Check whether the originals are
suitable to be scanned by the
machine.
"Error has occurred in the
scanner driver."
An error has occurred in the
driver.
• Check whether the network cable
is connected correctly to the client
computer.
• Check whether the Ethernet board
of the client computer is
recognized correctly by
Windows.
• Check whether the client
computer can use the TCP/IP
protocol.
10. Troubleshooting
236

Ricoh MP 3054 Series Specifications

General

Print Speed	30 ppm
Copy Resolution	600 x 600 dpi
Duplex Printing	Yes
Monthly Duty Cycle	50, 000 pages
Maximum Paper Size	A3
Warm-up Time	20 seconds
Memory	2 GB RAM
Scan Resolution	600 dpi
Paper Capacity	4, 700 sheets
Connectivity	USB 2.0, Ethernet 10/100Base-TX
Functions	Print, Copy, Scan
Scan Speed	80 ipm (simplex)
Control Panel	Touchscreen
First Print Speed	4.6 seconds
Hard Disk Drive	320 GB
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac, Linux
Print Resolution	Up to 1200 x 1200 dpi