To Next PageTo Next PageWhat to do if documents don't print from Ricoh All in One Printer?
If documents and reports from your Ricoh All in One Printer aren't printing, it could be due to a full paper output tray. Make sure to remove the printed papers from the tray. Also, check if the printer is out of paper and load paper if necessary.
Why does my Ricoh All in One Printer keep misfeeding?
Frequent misfeeds in your Ricoh All in One Printer can be caused by several factors. Curled paper can lead to misfeeds, so flatten the paper or load it with the curled edges facing downward. Ensure that the tray's side and end fences are set properly and locked. If you're using paper of an undetectable size, specify the paper size using the control panel. Finally, make sure there isn't any foreign object on the output tray.
What to do if error message persists after removing misfed paper from Ricoh All in One Printer?
If an error message persists on your Ricoh All in One Printer even after removing the misfed paper, fully open the front cover and then close it. Also, ensure that no paper is still jammed in the tray.
General| Print Technology | Laser |
|---|---|
| Resolution | 1200 x 1200 dpi |
| Functions | Print, Copy, Scan, Fax |
| Duplex Printing | Yes |
| Monthly Duty Cycle | Up to 150, 000 pages |
| Copy Resolution | 600 x 600 dpi |
| Fax Speed | 33.6 kbps |
| Processor | 533 MHz |
| Operating System Compatibility | Windows, Mac OS, Linux |
| Print Speed | 40 ppm (A4) |
| Connectivity | USB, Ethernet |
| Supported Paper Sizes | A3, A4, A5, B4, B5, Letter, Legal, Executive, Folio |
| Scanner Type | Flatbed, ADF |
| Scan Resolution | 600 dpi |
| Copy Speed | 40 cpm (A4) |
| Control Panel | color touchscreen |
| Memory | 1.5 GB RAM |
