Category Item Settings
Security Device Certificate
Certificate 1
Request
Configure this to create the request
form for the certificate authority to issue
the device certificate.
If you are using a self-signed device
certificate, you do not need to
configure this setting.
Of the settings for the device certificate
(certificate issued by the certificate
authority), set "Algorithm Signature" to
one of the following:
• sha512WithRSA-4096
• sha512WithRSA-2048
• sha256WithRSA-4096
• sha256WithRSA-2048
• sha1WithRSA-2048
• sha1WithRSA-1024
Submit the application form to request
that the certificate authority issue the
device certificate.
The request method depends on the
certificate authority. For details, contact
the certificate authority.
You can install the certificate issued by
the certificate authority via Web Image
Monitor.
Security Device Certificate Install To use the device certificate (issued by
the certificate authority), install the
certificate by configuring this setting.
If using the intermediate certificate as
well, install that too.
Security Device Certificate
Install Intermediate
Certificate
When using an intermediate certificate,
configure this setting to install the
certificate.
Changing MFP Settings During Operation
37
To Next Page
Loading...
