4. In wireless LAN environments, when large volume printing is being conducted, the
job is cancelled in the middle of printing.
5. In wireless LAN environments, when the authentication methods WPA2 and
A-MPDU are enabled, printing might take a significant amount of time.
6. When the threshold for fragmentation is set in the access point settings, the MFP/LP
will fail to receive the packet data if the computer sends data that is larger than the
threshold that is set.
7. When scanning with "Hungarian" or "Polish" selected under "Cognitive Language"
in "OCR Settings", if the value of a Unicode character exceeds 256, then the
character will be converted to a question mark ("?").
8. If user authentication is enabled, the address book cannot be updated from Web
Image Monitor when the device is in energy-saving mode.
9. "Authenticating... Please wait..." will be displayed if a user logs in to a device with
CAP v2 (Hybrid mode) installed in the case that "Security Setting for Access
Violation" is set as "On" in UP --> System Settings --> Administrator Tools -->
Extended Security.
10. Reception error may occur with W-NET FAX.
11. SC991-00 (Recoverable software operation error) may occur.
12. Key operations may not be recognized when the machine returns from System
Settings to the previous screen.
13. Smart Operation Panel may not operate normally while the Smart Operation Panel
turns on or recovers from energy save mode.
14. SC673-10(Connection error of the Smart Operation Panel) may occur while the
Smart Operation Panel turns on or recovers from energy save mode.
Other changes:
1. When an MFP receives a print job that includes a user ID, the MFP can use the user
ID for authentication in embedded applications that support user code
authentication.
2. SP5-490-001 (MF Key Card: Job Permit Setting) is now available.
Note: Previously, this SP could only be used on machines sold in Japan.
3. Two SP modes (suffixes) were added to SC670 (Engine start up error):
01: Mechanical problem, -02: Firmware problem
4. The following SCs were changed so that the machine automatically reboots after
occurrence:
SC360 (TD sensor adjustment error)
SC491 (High voltage power source: charge/development: output error)
SC569 (Paper Exit/ Pressure Release Motor Error Detection)
SC682 (PCU: ID Chip Communication Error)
1. SC816-38 may occur while the machine is transitioning to STR mode.
2. Cannot print/copy while the machine is transitioning to STR mode.
3. The machine cannot recover from Energy Saver mode if the Energy Saver key is
pressed while the machine is transitioning to STR mode.
4. SC816-01 may occur at the completion of automatic engine maintenance (Ex, at the
completion of a job).
5. The backslash key on the external USB keyboard does not respond if the keyboard
is set for England.
6. SC899 may occur when launching or making a copy with the SmartSDK Copy app.
To Next Page
