Ricoh MP C4503 - Page 90

Technical Bulletin PAGE: 3/3
Reissued: 22-Dec-16
Model: MET-C1ab_SOP
Date: 01-Aug-13
No.: RD147034p
Version
Modified Points or Symptom Corrected
- The API for web applications might not work after updating the firmware.
12.84.2
Symptom corrected:
- If an error occurs during DSM scanner transmission and the job is cancelled, and
then the DSM scanner is reinitiated, a page might be missing from the result of the
scanned document.
Other changes:
- Smart Operation Panel supports IPv6.
12.72.7
Symptom corrected:
- Minor bug correction
12.72.6
Other changes:
Supports IPv6/DNS for @Remote.
IMPORTANT: To apply the above change, in addition to this firmware, make sure to
update the System/Copy firmware to Ver.2.24 or later.
12.72.5
Symptom corrected:
1. SC997 may occur when the User Tools key is pressed.
2. SC899 may occur when the machine is turned ON.
3. When simultaneously printing from AppleTalk on a Mac and a protocol other than
AppleTalk in Windows, an SC899 error might occur.
4. When PEAP or TTLS is used as the IEEE 802.1X authentication method and the
server certification check is disabled, the IP address might not be obtained after the
device is restarted.
12.72.4
Symptom Corrected:
1. [Embedded RC Gate]: "@Remote certificate updating..." is displayed and @Remote
communication is suspended if SSL communication with a router or proxy server
was suspended due to no response or detection of the RESET signal.
Note: A certificate update indicates that a request to update the certificate was sent
to the @Remote Center instead of performing the retry process.
IMPORTANT: To apply the above changes, make sure to update to the following
firmware as well:
System/Copy: v2.21 or later
2. When DHCP v6 is enabled, turning the power off and then on might cause a
memory leak.
12.72.3
1st Mass production