7. Tray 3 (LCT)
Consists of two paper trays.
You can load paper even if Tray 3 (LCT) is in use. It is okay to pull out the left half of the tray while Tray 3
(LCT) is in use.
8. Large capacity tray (LCT)
Paper is loaded here.
9. Lower paper trays
Consists of two paper trays.
10. Internal tray 2
If you select this as the output tray, copied/printed paper or fax messages are delivered here face down.
11. Bridge unit
Relays paper to the finisher.
12. Internal shift tray
Sorts and stacks multiple sheets of paper.
13. External tray
If you select this as the output tray, copied/printed paper and fax messages are delivered here face down.
14. Internal Finisher SR3130
Sorts, stacks, and staples multiple sheets of paper.
Copies can be punched if the optional punch unit is installed on the finisher.
15. Internal Finisher SR3180
Sorts and stacks multiple sheets of paper, and staples them without using staples.
16. Finisher SR3210
Sorts, stacks, and staples multiple sheets of paper. Consists of the following paper trays:
• Finisher upper tray
• Finisher shift tray
Copies can be punched if the optional punch unit is installed on the finisher.
17. Booklet Finisher SR3220
Sorts, stacks, and staples multiple sheets of paper. The saddle stitch function can staple multiple sheets of
paper in the center and fold them into booklets. Consists of the following paper trays:
• Finisher upper tray
• Finisher shift tray
• Finisher booklet tray
Copies can be punched if the optional punch unit is installed on the finisher.
Guide to Functions of the Machine's Options
41
To Next Page
Loading...
Need help?
General
