Ricoh MP C6502SP - Page 325

147
SettingActive IPv6 Stateless
Address 1
CTL
[00000000000000000000000000000000
0000h to
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF80h /
000000000000000000000000000000004
0h / -]
These SPs are the IPv6 status addresses (1 to 5)
referenced on the Ethernet or wireless LAN
(802.11b) in the format:
"Status Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
149
SettingActive IPv6 Stateless
Address 2
CTL
151
SettingActive IPv6 Stateless
Address 3
CTL
153
SettingActive IPv6 Stateless
Address 4
CTL
155
SettingActive IPv6 Stateless
Address 5
CTL
156
IPv6 Manual Address *CTL
[00000000000000000000000000000000
0000h to
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF80h /
000000000000000000000000000000004
0h / -]
This SP is the IPv6 manually set address referenced on the Ethernet or wireless LAN (802.11b)
in the format:
"Manual Set Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8 blocks of 16 bits each.
158
IPv6 Gateway Address *CTL
[00000000000000000000000000000000h
to FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFh/
00000000000000000000000000000000h
/ -]
This SP is the IPv6 gateway address referenced on the Ethernet or wireless LAN (802.11b).
The IPv6 address consists of a total 128 bits configured in 8 blocks of 16 bits each.
161
IPv6 Stateless Auto Setting *CTL
[0 or 1 / 1 / 1/step]
0: Disable, 1: Enable
Enables or disables the automatic setting for IPv6 stateless.
SP5-722 to 998 (Mode)
323